How to Break In Sharp Edge Resin Dice Without Chipping
By Foam Brain Games - Plastic and Metal RPG Dice, Enamel Pins, and | Published: 2026-10-16
Category: Tips & Care
Sharp edge resin dice need gentle handling, not force. Follow these steps to break them in, protect the edges, and avoid chips during early rolls.
Quick answer
Break in sharp edge resin dice by rolling them on a soft, padded surface for short sessions, starting with lighter rolls and gradually increasing force. Avoid hard tables and gritty surfaces, and never use abrasive polishes on the edges. This gentle approach lets the edges settle without chipping.
Why sharp edge resin dice need a break-in period
Sharp edge resin dice are cast in molds that leave crisp, thin edges. These edges are more fragile than rounded ones, especially in the first few rolls when microscopic burrs or mold lines may still be present. Rolling on a hard surface can chip or crack these edges, so a gradual break-in helps the resin adapt to impact.
Unlike metal dice, resin is less forgiving of direct force. The goal is to let the edges wear in slightly without causing fractures. Using a dice tray with a soft lining, like felt or velvet, reduces impact and spreads force across the die face.
Step-by-step break-in process
Follow these steps in order. Each step includes a checkpoint to help you avoid common mistakes.
Break-in steps
- Step 1: Inspect the edges: Hold each die under good light and look for mold lines, burrs, or tiny chips. Run a fingernail gently along the edges to feel for rough spots. Checkpoint: If you find a burr, do not pick at it. Proceed to step 2.
- Step 2: Set up a soft rolling surface: Place a dice tray with a felt or velvet lining on a stable table. Avoid rolling directly on wood, glass, or stone. Checkpoint: The surface should have a little give but not be so soft that dice bounce out.
- Step 3: Start with light rolls: Roll each die gently from a low height, about 2–3 inches. Do this 10–15 times per die, focusing on the D20 and D12 first. Common mistake: Rolling too hard too soon can chip edges. Keep it light.
- Step 4: Gradually increase force: Over the next few sessions, roll from a slightly higher height and with a bit more force. Stop if you hear a sharp click or see a chip. Checkpoint: After each session, re-inspect edges for new damage.
- Step 5: Clean and polish gently: Wipe dice with a soft microfiber cloth. If you want to polish, use a plastic-safe polish and a soft cloth, avoiding abrasive compounds. Common mistake: Using metal polish or abrasive pads can dull edges and cause scratches.
- Step 6: Store properly between sessions: Keep dice in a soft bag or padded box. Do not toss them loose in a hard container with metal dice. Checkpoint: Separate resin dice from metal dice to prevent impact damage.
Product facts
- Fae Mushrooms RPG Dice Set: Fae Mushrooms RPG Dice Set includes 7 polyhedral dice: D4, D6, D8, D10, D%, D12, D20. A full set gives you multiple dice to practice the break-in process, so you can start with the larger dice and work down to smaller ones.
